# KS0008 keyestudio Joystick Module

![](media/wps1.jpg)

## 1. Introduction

Lots of robot projects need joystick. This module provides an affordable solution. By simply connecting to two analog inputs, the robot is at your commands with X, Y control.

It also has a switch that is connected to a digital pin. This joystick module can be easily connected to Arduino by IO Shield.

## 2. Specification

- Supply Voltage: 3.3V to 5V
- Interface: Analog x2, Digital x1

## 3. Connection Diagram

![](media/wps2.png)

## 4. Sample Code

Download code :  [Code](./Code.7z)

```c
int JoyStick_X = 0; //x
int JoyStick_Y = 1; //y
int JoyStick_Z = 3; //key

void setup() 
{
  pinMode(JoyStick_Z, INPUT); 
  Serial.begin(9600); // 9600 bps
}

void loop() 
{
  int x,y,z;
  x=analogRead(JoyStick_X);
  y=analogRead(JoyStick_Y);
  z=digitalRead(JoyStick_Z);
  Serial.print(x ,DEC);
  Serial.print(",");
  Serial.print(y ,DEC);
  Serial.print(",");
  Serial.println(z ,DEC);
  delay(100);
}
```

## 5. Result

![](media/wps3.jpg)

Wiring well and uploading the code, open the serial monitor and set the baud rate to 9600, push the joystick, you will see the value shown below.

![](media/wps4.png)