# KS0279 keyestudio Slide Potentiometer Module for Arduino

![](media/wps1.png)

## 1. Introduction

Keyestudio slide potentiometer module using high-quality sliding electrical appliance, has the performances of stability and reliability. 

It is a dual analog output, and outputs 0-VCC analog voltage signal.

## 2. Specification

- Voltage：3.3V、5V
- Port：analog quantity
- Resistance value：5K
- Platform：Arduino、microcontrollers、ARM and other microcontrollers platform
- Dimensions：90mm * 27mm * 30mm
- Weight：14.7g

## 3. Connection Diagram

![](media/wps2.png)

## 4. Sample Code

Download code :  [Code](./Code.7z)

```c
void setup() 
{
  // initialize serial communication at 9600 bits per second:
  Serial.begin(9600);
}

// the loop routine runs over and over again forever:
void loop() 
{
  // read the input on analog pin 0:
  int sensorValue = analogRead(A0);
  // print out the value you read:
  Serial.println(sensorValue);
  delay(1);        // delay in between reads for stability
}
```

## 5. Test Result

After connecting and burning the program, powered-on, open the serial monitor, and you can see the analog value of analog port A0, as the figure shown below.

When sliding the slide pole, the value ranges from 0 to 1023.

![](media/wps3.jpg)